Introduction 
 The core component of electronic endoscopy: With the advancement of technology and the development of detection methods, non-optical electronic endoscope fiber optic endoscope to replace the traditional camera and post the ultimate product, the principle is the traditional rear-mounted camera high-density integrated manufacturing process, about 1,200 times smaller in size so that it can be placed on spy head (probe) the front of the image information directly to the feedback. The image quality has been essentially improved. Solve the small number of pixels of light, the low image quality, image bundles easily broken wire (that is, usually called "black spots"), light and low utilization problem. 
 High-resolution image quality basic guarantee: HX series of electronic endoscopic imaging systems are used CCD (Charged Coupled Device) image sensor, enabling low-light imaging and other special requirements. 

 Technical parameters 
 Image Sensor: 1 / 6 "CCD 
 Head size: Φ5.5mmX8 ~ 12mm 
 Signal to noise ratio: greater than 49dB 
 White Balance: Auto + Manual 
 Minimum Illumination: 0.5 Lux F1.2 5600K 
 Lens: industrial self-focusing lens (optional) 
 Depth 5mm ~ 100mm 
 Depth 10mm ~ 100mm 
 Depth 10mm to infinity 
 Effective resolution: PAL: 752X582/NTSC: 768X494 
 Video Signal System: PAL / NTSC 
 Scanning System: Progressive scan, 625 lines / 50Hz (PAL); 525 lines / 60Hz (NTSC) 
 Image Control Unit CCU: SONY DSP main chip 
 Output: Line Line Length: 3.5 m 
 Output Signal: S-Video (1Vcc & 0.3Vcc/75Ω) / Video (1Vcc/75Ω) 
 USB2.0 output (optional) 
 4 screen freezes, VGA output (optional) 
 Image recording unit (optional) 
 Product Notes 
 ? The image modules are sophisticated electronic devices, storage, transport and use, do not severe vibration, drop, dip in water or in hot and humid environment. Do not dirty the installation process, pollution or scratch CCD surface, do not force pulling or bending force signal cable. 
 ? Connect the power supply completely correct when you make sure the power, voltage, current, power only after full compliance will cause irreparable damage such as CCD burned. 
 ? The image module using a special welding process, Please do not remove or replace any of the Main Board and the sensor device, otherwise it will cause damage and other consequences.